Skip to content
Boddy Viðgerðir Henriks

Land Cruiser BJ42 — the body reassembled after painting

The body came back painted and went together again: panels hung up, the underside finished and the body set back on the chassis.

Vehicle
Toyota Land Cruiser BJ42
Service
Classic car restorationRustproofing

With the body back from paint, the reassembly began. Each panel was hung up while it waited its turn: doors, frames, wings, steps and smaller pieces, each in its place in the sequence.

The underside was finished before the body went back on the chassis. That is the right moment for it — when everything is reachable without working around crossmembers, and before the car stands on its wheels again.

The last photographs show the car outside the workshop with the body back on the chassis. It was not finished at that point, but this is the moment a car stops being a stack of panels and becomes a car again.

Photographs of the job

Painted panels and steps for a Land Cruiser BJ42 on the workshop floorIn progress
Painted door frame of a Land Cruiser BJ42 hanging upIn progress
Painted side frame of a Land Cruiser BJ42 hanging from the liftIn progress
Painted body panels of a Land Cruiser BJ42 hanging in a rowIn progress
Painted rear wing of a Land Cruiser BJ42 hanging upIn progress
Panels of a Land Cruiser BJ42 hanging in the workshop after paintingIn progress
Painted door of a Land Cruiser BJ42 ready to be fittedIn progress
Underside of a Land Cruiser BJ42 finished, seen from below on the liftIn progress
The underside finished before the body went back on the chassis.
Underside of a Land Cruiser BJ42 with the axle seen from belowIn progress
White Land Cruiser BJ42 body back on its chassis outside the workshopAfter
The body back on the chassis.
Land Cruiser BJ42 on its wheels outside the workshop in GarðabærAfter
Land Cruiser BJ42 from the front with grille and headlight openingsAfter
Land Cruiser BJ42 from the front at night beneath the workshop signAfter

The service behind this job

More work

See all work
New body mounts and rubbers ready for a Land Cruiser BJ42

Toyota Land Cruiser BJ42

Land Cruiser BJ42 — the car back together

The final stage: new body mounts, doors and front end fitted, sound deadening in the bed — and the BJ42 out of the workshop on its own wheels.

Read more
White VW Beetle outside the workshop before the floor repair began

Volkswagen Bjalla

VW Beetle — new floor pans welded in

The floor of this Beetle was gone on both sides. New floor pans went in, were welded up and the underside protected — a car that stood on a perforated floor now stands on a sound one.

Read more
Section cut out of the inner sill of a Land Cruiser, eaten through by rust

Toyota Land Cruiser

Sill repair on a 25-year-old Land Cruiser

Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.

Read more

Get in touch

Tell us what the car needs. Calling is quickest, and the same number takes photographs on WhatsApp.

Address

Boddy Viðgerðir Henriks
Suðurhraun 2b
210 Garðabær

Plus Code: 33HF+CM Garðabær

Get directions

Opening hours

Monday–Friday
09:00–17:00
Saturday–Sunday
Closed

Call ahead for a larger job, so the car can be taken in at the right time.

Book a timeCall