
Toyota Land Cruiser BJ42
Land Cruiser BJ42 — the car back together
The final stage: new body mounts, doors and front end fitted, sound deadening in the bed — and the BJ42 out of the workshop on its own wheels.
Read moreJobs that have been through the workshop, each one shown from how the car arrived to how it left.

Toyota Land Cruiser BJ42
The final stage: new body mounts, doors and front end fitted, sound deadening in the bed — and the BJ42 out of the workshop on its own wheels.
Read more
Volkswagen Bjalla
The floor of this Beetle was gone on both sides. New floor pans went in, were welded up and the underside protected — a car that stood on a perforated floor now stands on a sound one.
Read more
Toyota Land Cruiser
Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.
Read more
Toyota Land Cruiser 90
The floor of a modified Land Cruiser 90 was gone over a large area. New panels were shaped from the old one, welded in and the surface protected.
Read more
Lincoln Continental, 1964
The doors on a 1964 Lincoln Continental were rusted through along the bottom, inside and out. The lower section was rebuilt from scratch.
Read more
Toyota Hilux
Bed, interior and trim removed from a modified Hilux to reach the chassis, floor and cavities — and protect them before the next winter starts.
Read more
Toyota Land Cruiser BJ42
The body came back painted and went together again: panels hung up, the underside finished and the body set back on the chassis.
Read more
Plymouth Barracuda, 1971
The doors on this Barracuda were taken apart, the inner frames repaired, and new door skins folded and fitted in the workshop.
Read more
Toyota Land Cruiser 120
The rear crossmember under a Land Cruiser 120 was eaten through. A new one was fabricated and welded in its place.
Read more
Chevrolet Camaro IROC-Z
The Camaro was stripped and turned on its side so the underside, floors and rails could be worked as if they lay on a bench.
Read more
Toyota Land Cruiser BJ42
Doors, roof, wings, sills, floors and brackets rebuilt on a BJ42, one piece at a time, with the chassis stripped and painted alongside.
Read more
Ford Torino
The lower flange of the inner front wing on this Torino was perforated by rust. A new flange was formed and welded in, side by side.
Read more
Toyota Land Cruiser 100
A white Land Cruiser 100 with rust where it usually starts on this model: at the ends of the sill and in the corner by the rear wheel arch.
Read more
Lincoln Continental, 1964
The rear corner on this Continental was not available as a part. It was made here, from the old one, and welded in.
Read more
Rust in the sill and front wheel arch of a 4x4: cut out, new steel welded in, and the area masked and protected before the vehicle went out.
Read more
Mercedes-Benz G-class AMG
A shock absorber mount on a G-Class was renewed and the area protected before the new damper went on.
Read more
Toyota Land Cruiser BJ42
A classic that looks sound from outside can be another matter within. The interior came out of this BJ42, every rusted area was photographed, and the body was finally lifted off the chassis.
Read more
Lincoln pallbíll
Rust in the cab corner and in the sill under the door. Cut out, new steel welded in and the surface prepared for finishing.
Read more
Toyota Hilux
Before and after on the chassis of a Hilux: rusted and grit-covered on one hand, cleaned and protected on the other.
Read more
Ford Excursion
A big vehicle, a long sill and rust running its full length. Doors off and the damage photographed before anything began.
Read more
Toyota Land Cruiser 90
Rust at the body mounts is invisible unless you get under the car. On a Land Cruiser 90 that is exactly where it sits.
Read more
Jeep Grand Cherokee V8
Doors removed so what lay under the sill trim could be seen — and what actually needed repair.
Read more
Toyota Land Cruiser 100
Doors, wings and tailgate off, so what lies underneath can be seen. That is how a restoration starts on a car that is meant to keep going.
Read moreTell us what the car needs. Calling is quickest, and the same number takes photographs on WhatsApp.
Call ahead for a larger job, so the car can be taken in at the right time.