Sill repair on a 25-year-old Land Cruiser
Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.
- Vehicle
- Toyota Land Cruiser
The car came in with rust in the sill. Once the cover was off it was clear this was not a surface blemish: the rust had gone right through, working from the inside as it always does when water gets into the cavity and finds no way out again.
The pieces in the photographs are what came out of the car. One is from the inner sill, eaten through over a long stretch; the other is the outer skin you see from outside, which had started to give way along the whole lower edge. This is typical of a car of this age that has stood through Icelandic winters — the damage is always larger than the bubble showing in the paint.
We cut back until clean steel was left on every edge. New pieces were shaped to the original profile of the sill, welded in, and the welds ground back until the surface was straight and the line was right. Finally the area was finished off and the lower edge and wheel arch protected, so water and salt do not settle in the same place again.
The car is in daily use, so the repair had to hold as structure, not merely look right from the outside.
Photographs of the job
In progress
In progress
In progress
After
After


