1964 Lincoln Continental — new rear corner fabricated
The rear corner on this Continental was not available as a part. It was made here, from the old one, and welded in.
- Vehicle
- Lincoln Continental, 1964
The rear corner is where the side, the wing and the rear end all meet. The shape curves in two directions and very little of it is flat, so it is not a part you cut from sheet and make do with.
The old corner was gone and is not available to buy. A new one was formed from sheet, offered up to the car again and again until the lines matched the wing and the rear end, and finally welded in.
This is the part of classic work that takes time and shows least. Done right, nobody notices the corner — which is exactly the point.
Photographs of the job
In progress
In progress


