Skip to content
Boddy Viðgerðir Henriks

Land Cruiser BJ42 — mapping the rust and lifting the body off the chassis

A classic that looks sound from outside can be another matter within. The interior came out of this BJ42, every rusted area was photographed, and the body was finally lifted off the chassis.

Vehicle
Toyota Land Cruiser BJ42
Service
Classic car restorationRust repair

The car arrived looking whole: white, with its chrome trim, everything in place. That says little about the steel underneath, which is why a job like this always starts the same way — the interior comes out, carpets and trim with it, and then you see what is actually left.

The rust was in the floor, in the load area, in the seams along the sides, at the body mounts, in the sills and around the battery tray in the engine bay. In places the paint was intact from outside although the steel beneath was gone; that is typical once water gets into a cavity and works from the inside. We photograph every area before touching it, so the owner can see for himself what was wrong.

With the extent established, the body was lifted off the chassis. That is the only way to reach everything: the underside of the floor, the mounts and the chassis itself. These photographs show the car as it came in and how it stood when the preparation was finished.

Photographs of the job

White Land Cruiser BJ42 with chrome trim inside the workshop as it arrivedBefore
The car as it came in.
Land Cruiser BJ42 from the front with doors open before work beganBefore
Load area of a Land Cruiser BJ42 opened up, floor rusted under the trimBefore
Rear doors opened and the floor uncovered.
Rust in the floor of a Land Cruiser BJ42 by the wheel arch and seatBefore
Rusted floor under the seat of a Land Cruiser BJ42Before
Rust along the side of the load floor in a Land Cruiser BJ42Before
Rust in the rear floor and wheel arch of a Land Cruiser BJ42Before
Rust in the seam at the rear corner of a Land Cruiser BJ42Before
Rusted seam along the rear side panel of a Land Cruiser BJ42Before
Rust hole in the floor of a Land Cruiser BJ42 around the drain plugBefore
The hole started as a small bubble in the paint.
Rust along the sill inside the door opening of a Land Cruiser BJ42Before
Rust where the floor meets the sill in a Land Cruiser BJ42Before
Rust in the inner rear corner of a Land Cruiser BJ42Before
Rust at the bottom of the sill of a Land Cruiser BJ42 seen from outsideBefore
Lower edge of the sill on a Land Cruiser BJ42 eaten away by rustBefore
Rust at the rear body mount of a Land Cruiser BJ42Before
Underside of the body on a Land Cruiser BJ42 with rust at a mountBefore
Rear corner and body mount of a Land Cruiser BJ42 seen from the sideBefore
Engine bay of a Land Cruiser BJ42 with a rusted battery trayBefore
Front of the engine bay in a Land Cruiser BJ42 with rust by the radiatorBefore
Battery tray removed from a Land Cruiser BJ42 revealing rust in the inner wingIn progress
Land Cruiser BJ42 with the front end removed, up on standsIn progress
Body mount on a Land Cruiser BJ42 with a rusted plateBefore
Underside of a Land Cruiser BJ42, differential and crossmemberBefore
Underside of the floor and body on a Land Cruiser BJ42Before
Paint blisters opened up on the body of a Land Cruiser BJ42In progress
A paint blister always turns out bigger once it is opened.
Rust ground back to bare steel on the body of a Land Cruiser BJ42In progress
Inner panel and mount cleaned up on a Land Cruiser BJ42In progress
Rust in the rear body corner above the chassis on a Land Cruiser BJ42Before
Rear wing and inner arch above the axle on a Land Cruiser BJ42Before
Underside of the rear body and wheel arch on a Land Cruiser BJ42Before
Inner sill and floor of a Land Cruiser BJ42 opened up with a jack underneathIn progress
A cut-out rusted section held up against the body of a Land Cruiser BJ42In progress
This is what the steel looks like when water has sat inside the cavity.
Body of a Land Cruiser BJ42 lifted off the chassis and set on the floorIn progress
Body off the chassis — the only way to reach everything that needs work.
Chassis of a Land Cruiser BJ42 with the engine, body removed, in the workshopIn progress

The service behind this job

More work

See all work
New body mounts and rubbers ready for a Land Cruiser BJ42

Toyota Land Cruiser BJ42

Land Cruiser BJ42 — the car back together

The final stage: new body mounts, doors and front end fitted, sound deadening in the bed — and the BJ42 out of the workshop on its own wheels.

Read more
White VW Beetle outside the workshop before the floor repair began

Volkswagen Bjalla

VW Beetle — new floor pans welded in

The floor of this Beetle was gone on both sides. New floor pans went in, were welded up and the underside protected — a car that stood on a perforated floor now stands on a sound one.

Read more
Section cut out of the inner sill of a Land Cruiser, eaten through by rust

Toyota Land Cruiser

Sill repair on a 25-year-old Land Cruiser

Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.

Read more

Get in touch

Tell us what the car needs. Calling is quickest, and the same number takes photographs on WhatsApp.

Address

Boddy Viðgerðir Henriks
Suðurhraun 2b
210 Garðabær

Plus Code: 33HF+CM Garðabær

Get directions

Opening hours

Monday–Friday
09:00–17:00
Saturday–Sunday
Closed

Call ahead for a larger job, so the car can be taken in at the right time.

Book a timeCall