Skip to content
Boddy Viðgerðir Henriks

Rust repair

Rust cut out and new steel welded in — not filled over.

Rust that has been filled and sprayed over always comes back, and worse than before. Here a rust repair means the affected steel is cut out, a new piece is shaped to the same form and welded in, and the weld is ground back until the surface is straight.

We also look for what is not visible from the outside. Rust starts on the inside: in seams, under trim, around drain channels, and wherever two panels sit tight together and hold water. A paint bubble the size of a coin can turn out to be the size of your hand once it is opened up.

The most common places are floors and floor pans, wheel arches and the lower edges of wings, window frames around the windscreen and rear window, and the chassis and mounting points underneath. Before welding we clean the rust off around the repair back to bare metal, so the new weld has sound steel to bond to.

How big the job is depends on the car. A small patch on a wing can go out the same day. Once rust has reached structure — A-pillars, rocker panels, floors or the chassis — the job is larger, and we go through it with you before starting. The same work applies to vans, work vehicles, trailers and caravans.

What the job involves

  • Affected steel cut out, not filled over
  • Floors and floor pans, wheel arches and wing edges
  • Window frames around the windscreen and rear window
  • Chassis, underside and mounting points
  • Rust cleaned back to bare metal before welding
  • Smaller patches often finished the same day
  • Vans, work vehicles, trailers and caravans too

Book a time765 0473All services

Work in this category

See all work
White VW Beetle outside the workshop before the floor repair began

Volkswagen Bjalla

VW Beetle — new floor pans welded in

The floor of this Beetle was gone on both sides. New floor pans went in, were welded up and the underside protected — a car that stood on a perforated floor now stands on a sound one.

Read more
Section cut out of the inner sill of a Land Cruiser, eaten through by rust

Toyota Land Cruiser

Sill repair on a 25-year-old Land Cruiser

Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.

Read more

Questions and answers

Is it cheaper to just fill over the rust?

At first, yes, but it does not last. Filler does not stop rust that keeps working from the inside, so the same panel has to be done again in a year or two — as a bigger job than before.

Do you repair rust in the floor of a car?

Yes. Rust in the floor and floor pans is cut out and new steel welded in, just as with sills and wheel arches. The floor is part of the car's structure, so it is repaired to hold — not merely to close the hole.

How long does a rust repair take?

One defined patch on a wing or a door is often a day's work. Rust in structure, such as an A-pillar or a rocker panel, takes longer because more has to be opened up, reinforced and welded.

Does your car have this?

Call and describe what you can see, and we will tell you what needs looking at.

Address

Boddy Viðgerðir Henriks
Suðurhraun 2b
210 Garðabær

Plus Code: 33HF+CM Garðabær

Get directions

Opening hours

Monday–Friday
09:00–17:00
Saturday–Sunday
Closed

Call ahead for a larger job, so the car can be taken in at the right time.

Book a timeCall