Skip to content
Boddy Viðgerðir Henriks

38-inch modified Land Cruiser 90 — a new floor fabricated

The floor of a modified Land Cruiser 90 was gone over a large area. New panels were shaped from the old one, welded in and the surface protected.

Vehicle
Toyota Land Cruiser 90
Service
Rust repairModifications and custom fabricationRepairs for vehicle inspection

The interior came out and what lay under the carpet showed itself: rust over a large area of the floor, worst where the seat mounts and seams run. On a modified vehicle used all year round that is not unusual — water and grit have an easy way in and none out.

The new floor was shaped from the old one. The sheet was measured, marked and folded here at the workshop, because a floor panel for these vehicles is not available ready-made. The old steel was cut away until clean metal was left on every edge, and the new panel welded in.

Finally the area was sealed and protected, above and below. A floor is structure: it holds the seat mounts and carries load in a collision, so it has to be done properly rather than simply closing the hole.

Photographs of the job

Rusted floor in a Land Cruiser 90 with the carpet removedBefore
This is how the floor looked once the carpet came out.
Rust in the floor of a Land Cruiser 90 at the seat mountsBefore
Perforated floor and rusted seams in a Land Cruiser 90Before
New floor panel measured and marked on the folder for a Land Cruiser 90In progress
The new panel shaped from the old one — it is not available ready-made.
New floor welded into a Land Cruiser 90 with the surface finishedAfter
New floor and sill edge in a Land Cruiser 90 seen from the door openingAfter
Finished floor in a Land Cruiser 90 with sealed jointsAfter
The surface sealed and protected, above and below.

The service behind this job

More work

See all work
New body mounts and rubbers ready for a Land Cruiser BJ42

Toyota Land Cruiser BJ42

Land Cruiser BJ42 — the car back together

The final stage: new body mounts, doors and front end fitted, sound deadening in the bed — and the BJ42 out of the workshop on its own wheels.

Read more
White VW Beetle outside the workshop before the floor repair began

Volkswagen Bjalla

VW Beetle — new floor pans welded in

The floor of this Beetle was gone on both sides. New floor pans went in, were welded up and the underside protected — a car that stood on a perforated floor now stands on a sound one.

Read more
Section cut out of the inner sill of a Land Cruiser, eaten through by rust

Toyota Land Cruiser

Sill repair on a 25-year-old Land Cruiser

Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.

Read more

Get in touch

Tell us what the car needs. Calling is quickest, and the same number takes photographs on WhatsApp.

Address

Boddy Viðgerðir Henriks
Suðurhraun 2b
210 Garðabær

Plus Code: 33HF+CM Garðabær

Get directions

Opening hours

Monday–Friday
09:00–17:00
Saturday–Sunday
Closed

Call ahead for a larger job, so the car can be taken in at the right time.

Book a timeCall