Skip to content
Boddy Viðgerðir Henriks

Sill and rocker panel repair

The sill is usually the first thing to go — and what stops a car passing inspection.

The sill and rocker panel sit lowest on the car and take everything: salt, grit, water and slush all winter. They are also double-skinned, with a cavity inside, and water gets in there far more easily than it gets out. That is why rust on a car usually starts here.

The repair is the same whether the car is a twenty-five-year-old 4x4 or a recent saloon: trim and covers off, the rusted steel cut out, a new piece shaped to the same curve and welded in, the weld ground back until the line is straight. Afterwards we rustproof the cavity we opened, because otherwise the same story starts over.

This is also the area an inspection takes seriously. Rust in a sill or rocker panel is not cosmetic — it is structure, and once it is gone the car is not as strong in a side impact. Even so, many sill jobs are well defined and finished in one or two days.

What the job involves

  • Sills, rocker panels and lower wings
  • New piece shaped to the original profile
  • The cavity rustproofed after welding
  • Structural work that vehicle inspection looks at
  • Defined jobs often done in one or two days

Book a time765 0473All services

Work in this category

See all work
Section cut out of the inner sill of a Land Cruiser, eaten through by rust

Toyota Land Cruiser

Sill repair on a 25-year-old Land Cruiser

Rust had eaten through the sill of a twenty-five-year-old Land Cruiser, both the inner structure and the outer skin. Everything that was gone was cut out, new pieces welded in and the lower edge protected.

Read more

Questions and answers

Will a car with a rusted sill pass inspection?

Rust in a sill or rocker panel is assessed as structure and can mean a re-inspection or a failure. It is cheaper to have it repaired before an inspection stops the car than after the rust has had another winter to work.

Does the whole sill have to be replaced?

Rarely. In most cases it is enough to cut out the section that is gone and weld in a new piece. We never cut more than needed, but never less than will hold either.

Does your car have this?

Call and describe what you can see, and we will tell you what needs looking at.

Address

Boddy Viðgerðir Henriks
Suðurhraun 2b
210 Garðabær

Plus Code: 33HF+CM Garðabær

Get directions

Opening hours

Monday–Friday
09:00–17:00
Saturday–Sunday
Closed

Call ahead for a larger job, so the car can be taken in at the right time.

Book a timeCall