Land Cruiser 100 — rust at the sill ends and wheel arch corner
A white Land Cruiser 100 with rust where it usually starts on this model: at the ends of the sill and in the corner by the rear wheel arch.
- Vehicle
- Toyota Land Cruiser 100
On a Land Cruiser 100 the rust nearly always starts in the same places. The ends of the sill come first, both at the front where grit off the tyre lands and at the rear in the corner up against the wheel arch. Panels meet there, moisture collects, and from there the rust works its way in.
The photographs show the condition as the car arrived: the paint split at the bottom of the sill, rust through the edge, and the underseal starting to lift in the wheel arch. The cover was taken off to see how far the damage reached, because that is not visible from outside and tapping tells you little.
A job like this is well defined. The affected steel is cut out, a new piece is shaped to the same curve and welded in, the surface ground straight, and the cavity protected before the cover goes back on. Rust in this spot is also what a vehicle inspection remarks on, so it pays to deal with it before it grows.
Photographs of the job
Before
Before
Before
Before
Before


