4x4 sill repair — wheel arch and lower edge
Rust in the sill and front wheel arch of a 4x4: cut out, new steel welded in, and the area masked and protected before the vehicle went out.
The front wheel arch and the front end of the sill take the heaviest punishment on a 4x4. Grit thrown up by the tyre lands there first, and there is a seam there that holds moisture.
Here the rust had gone through where the wheel arch meets the sill. It was cut out, new steel shaped and welded in, and the surface ground until the line was straight.
The area was then masked off and protected. That is the part most often skipped, and it is still the reason a repair lasts two years or ten.
Photographs of the job
Before
In progress
In progress


